Roofing Mesh Nz

Organic asphalt shingles begin with paper often recycled that is saturated in asphalt and covered with granules.

Roofing mesh nz.

The provision of a permanent safe working environment throughout the roof installation and for future maintenance work can be achieved by using the safety mesh system over the entire roof plane. Shingles made with fiberglass are lightweight and resist tearing. Also used to support underlays where spans fall outside recommended distances. Based in wellington we work with you to provide tailored solutions for commercial and residential buildings.

It also provides a permanent safe working environment under skylights and clear composition roofing. Suitable for both timber and steel structures. Also available with a pvc coating for improved rust resistance. Roof safety mesh is welded steel mesh attached to roof framing to eliminate the risk of falls during construction as well as acting as a support for the roofing underlays and insulation and any further roof maintenance work.

Consists of a welded mild steel wire mesh with longitudinal wires spaced at 150mm centres and cross wires spaced at 300mm centres. 50mm mesh size must be used where the wind zone is very high or where heavy weight underlay is to be used e g. Bayonet galvanised 50mm and 75mm wire netting is suitable for supporting building paper or roofing underlay when the wire netting is supported by timber or steel roof or wall framing. Exact cut service provides precise lengths for each job.

C3 9 roof safety mesh is intended to control the risk of fall hazards over the entire roof area including penetrations both during construction and after the building enters service. We offer a wide range of kiwimade wire netting and mesh including chain link hexagonal rabbit netting and docking netting. Galvanised safety mesh complying with as nzs 4389 2015 for use in commercial roof applications where falling from high hazards exist. The longitudinal wires are spaced at 150mm centres with crosswires spaced at 300mm centres.

The longitudinal wires are spaced at 150mm centres with crosswires spaced at 300mm centres. Galvanised safety mesh complying with as nzs 4389 2015 for use in commercial roof applications where falling from high hazards exist. In all non residential roofing systems. Safety mesh consists of 2mm galvanised wire with a tensile strength exceeding 450 mpa.