Place the leading edge of the first panel along this line.
Roofing felt installation instructions for wall covering.
Install the panel so that the short lip overlaps the large lip.
The purpose of this guide is to.
The roofing felt should be applied in layers that overlap.
Measure one panel width in from the roof edge.
2 corrugated metal roof installation instructions.
Roofer s guide to roof installation.
Install the panels tape the seams with zip system tape.
Proper safety equipment is recommended for all installations.
Fasten drip edge on eaves with.
Buy the metal panels.
Finish the first side of the roof.
This increases the water shedding ability of organic roofing felt.
2 roofing felt should be installed from the bottom of the roof deck in horizontal layers.
Installation manual 6 zip system sheathing and tape zip system sheathing overview.
It is extremely important that this panel be laid square to the eave and ridge so that the remaining panels will line up square on the roof frame.
It s important to do the.
The first layer of felt should be installed to cover the entire bottom edge of deck.
The silicone will spread and adhere creating a seal.
Continue adding panels until the roof is covered.
As you work the paper can be tacked down in the center so it won t blow away.
1 the roofing deck must be clear of all debris and moisture prior to installation of organic roofing felt.
If scuffing occurs cover any scuffed areas with an additional layer of feltbuster high traction synthetic roofing felt that exceeds the scuffed area by 6 152 mm on each side.
Sidewall and front wall flashing 167 extended warranty coverage 168 resources 169 glossary 170 174 pg 6 roofing safety safety the best form of accident insurance is accident prevention.
Lay and secure the first metal panel.
Synthetic roofing felt against the deck.
Zip system roof and wall sheathing panels are oriented strand board osb wood structural panels with built in protective overlays that eliminate the need for building wrap or roofing felt.
Start at the bottom of the roofline and work up so any water that gets through the roofing material will shed down the tar paper and will not go under it.
Roofing felt installation recommendations be aware that roofing felt should not be walked upon prior to nailing into position.
Complete the first row.
Nail metal drip edge flashing which bends over the roof and down the edge of the facing board on all roof edges.
Installing roof felt is a two person job.
Screw the new panel in place as described.
Adhere the additional layer of feltbuster high traction synthetic roofing felt with a moisturecurable.
Lay the roofing felt.
At this point chalk a line from ridge to eave.
